Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
3. If removed, use the special tools to install the dust seal.
4. NOTE: Install the halfshaft in a soft-jaw vise.
NOTE: The lip on the end of the tri-lobe insert must seat against the end of the boot.
For the inboard CV joint, carry out the following:
1
Position the clamp on the interconnecting shaft.
2
Position the boot on the interconnecting shaft.
3
Install the tri-lobe insert.
5. NOTE: One side of the inboard CV joint has a chamfer cut in the edge of joint at the inner diameter near the splines. Install the inboard CV joint
so that the chamfer faces the outboard end of the halfshaft.
Install the CV joint.
6. Install the retainer circlip.
