Expedition 4WD V8-5.4L SOHC VIN 5 (2005)
Wheel Bearing: Service and Repair
Rear
Wheel Bearing and Wheel Hub
Removal and Installation
WARNING: The electrical power to the air suspension system, must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the LH rear quarter trim panel. Failure to do so can
result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
1. If equipped, turn the air suspension switch to the OFF position.
2. Remove the wheel and tire assembly.
3. NOTE: Have an assistant press the brake pedal to keep the axle from rotating.
Remove and discard the rear axle wheel hub retainer and the washer
4. Using a suitable hub puller, separate the outboard CV joint from the wheel hub.
5. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can result.
Remove the bolts, and position the caliper, pads and anchor plate aside.
