Expedition 4WD V8-5.4L SOHC VIN L (2000)
10. Install the line brackets.
1
Position the bracket.
2
Install the nut.
3
Snap the line securely into the bracket.
CAUTION: Overtightening of the nut will cause the stud to break away from the floor pan.
NOTE: The bracket must be positioned equally between the white location marks on the line.
11. Install the muffler heat shield.
1
Position the shield.
2
Install the nuts.
12. Lower the vehicle.
13. Turn on the air suspension switch, if equipped.
14. Install the grommet seal and retainer.
NOTE: Verify that the lines are entering through the center of the floor opening and that the retainer locating marks are positioned correctly.
15. Connect the heater inlet hose coupling.
16. Install the quarter trim access panel.
17. Install the spare tire.
18. Fill the cooling system. For additional information, refer to Cooling System.
Outlet
