Expedition 4WD V8-5.4L VIN 5 (2006)
-
CHECK ENGINE TEMPERATURE
-
TEMPORARY 4x4 HIGH
-
CHECK ADV/TRAC
-
CHECK TIRE PRESSURE
The repetitive warning messages are displayed at a fixed interval whenever the ignition switch is turned ON or is in the ACC position. To remove a
repetitive warning message, press the RESET button. The message only reoccurs after 10 minutes or until the warning condition is corrected.
The non-resettable warning messages are:
-
DOOR AJAR
-
STOP ENGINE SAFELY
-
REDUCED ENGINE POWER
-
ENGINE FAILSAFE MODE
-
PARK ASSIST ON/OFF
-
TRAIN LF TIRE
-
TRAIN LR TIRE
-
TRAIN RF TIRE
-
TRAIN RR TIRE
-
TRAIN SPARE TIRE
-
TIRE TRAINING MODE COMPLETE
-
TIRES NOT TRAINED
-
PARK BRAKE ENGAGED
The non-resettable warning messages display whenever the ignition switch is turned to ON and a fault occurs in a system. The fault must be corrected
to clear the non-resettable warning messages.
Inspection and Verification
INSPECTION AND VERIFICATION
1. Verify the customer concern.
Visual Inspection Chart
2. Visually inspect for obvious signs of mechanical or electrical damage.
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. If the cause is not visually evident, connect the diagnostic tool to the data link connector and select the vehicle to be tested from the diagnostic tool
menu. If the diagnostic tool does not communicate with the vehicle:
-
check that the program card is correctly installed.
-
check the connections to the vehicle.
-
check the ignition switch position.
5. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
6. Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
-
ISO, SCP or CAN circuit fault; all electronic control units no response/not equipped, refer to Information Bus (Module Communications
Network).
-
No response/not equipped for the instrument cluster, refer to Instrument Cluster.
-
System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out self-test
diagnostics for the instrument cluster.
7. If the DTCs retrieved are related to the concern, refer to the Instrument Cluster Diagnostic Trouble Code (DTC) Index. See: Diagnostic Trouble
Code Descriptions
8. If no DTCs related to the concern are retrieved, GO to Symptom Chart. See: Symptom Related Diagnostic Procedures
