Expedition 4WD V8-5.4L VIN 5 (2006)
Front Door Exterior Handle: Service and Repair
Door Handle
EXTERIOR FRONT DOOR HANDLE
Removal and Installation
NOTE: The front door window glass must be completely raised.
1. Remove the front door trim panel.
2. Position the watershield aside.
3. Open the clip and disconnect the exterior door handle actuating rod.
4. If equipped, disconnect the door lock cylinder actuating rod from the lock cylinder.
5. NOTE: Push the exterior door handle out from the bottom surface of the handle.
Remove the 2 nuts and the exterior front door handle.
-
To install, tighten to 9 Nm (80 lb-in).
6. NOTE: Make sure the door handle and the front door handle rod is in a relaxed position and that the front door handle rod are all the way up
before closing the clips.
To install, reverse the removal procedure.