Expedition 4WD V8-5.4L VIN 5 (2006)
NOTE:
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Position the seat to gain access to all seat track-to-floor fasteners.
2. Depower the SRS.
3. Remove the 60 percent seat.
4. Remove the 60 percent seat backrest.
5. Remove the armrest bracket inner cover.
6. Remove the 2 screws and the armrest bracket outer cover.
7. Release the cushion trim cover J-clips.
8. Remove the 2 bolts and the backrest recliner.
-
To install, tighten to 50 Nm (37 lb-ft).
9. Remove the 2 bolts and the armrest bracket.
-
To install, tighten to 50 Nm (37 lb-ft).
10. Remove the seat track.
11. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from
the cushion foam pad.
Invert the cushion trim cover and remove from the cushion foam pad.
12. Remove the cushion foam pad from the cushion frame.
13. To assemble, reverse the disassembly procedure.
14. Install the 60 percent seat backrest.
15. Install the 60 percent seat.
16. Repower the SRS.
