Expedition 4WD V8-5.4L VIN 5 (2006)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Front
Wheel Speed Sensor - Front
Removal and Installation
1. NOTE: If equipped, turn the air suspension switch to the OFF position.
With the vehicle in NEUTRAL, position it on a hoist
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the wheel speed sensor harness retainer bolt and detach the retainers.
^
To install, tighten to 12 Nm (9 ft. lbs.).
4. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can result.
Remove the 2 caliper anchor bolts and position the caliper, pads and anchor plate aside.
^
Support the caliper with mechanic's wire.
^
To install, tighten to 200 Nm (148 ft. lbs.).
5. Remove the brake disc.
6. Remove the front wheel speed sensor bolt and the sensor.
^
To install, tighten to 18 Nm (13 ft. lbs.).
7. To install, reverse the removal procedure.
