Expedition 4WD V8-5.4L VIN 5 (2006)
Yaw Rate Sensor: Service and Repair
Stability Control Sensor Cluster
Removal and Installation
NOTE: The lateral and longitudinal accelerometer and the roll rate sensor are located within the yaw rate sensor, stability control sensor cluster.
1. Remove the front floor console. For additional information, refer to Console.
2. Disconnect the stability control sensor cluster electrical connector.
3. Remove the 2 bolts and the stability control sensor cluster.
^
To install, tighten to 12 Nm (9 ft. lbs.).
4. To install, reverse the removal procedure.
