Expedition 4WD V8-5.4L VIN 5 (2006)
Remove the 2 bolts and the RH cylinder head camshaft front bearing cap.
13. NOTICE: The camshaft bearing caps must be installed in their original locations. Record camshaft bearing cap locations. Failure to follow these
instructions may result in engine damage.
Remove the remaining bolts in the sequence shown and remove the RH cylinder head camshaft bearing caps.
14. Clean and inspect the RH camshaft bearing caps.
-
The camshaft front thrust bearing cap contains an oil metering groove. Make sure the groove is free of foreign material.
15. NOTICE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
NOTICE: Only use hand tools to remove the camshaft phaser and sprocket bolt or damage may occur to the camshaft or camshaft phaser and
sprocket.
NOTICE: Do not remove the Timing Chain Wedge tool at any time during assembly. If the special tool is removed or out of placement, the
engine front cover must be removed and the engine must be retimed. For additional information, refer to Timing Drive Components. See: Timing
Components
