Expedition 4WD V8-5.4L VIN 5 (2006)
Muffler: Service and Repair
Muffler and Tailpipe
Removal and Installation
CAUTION: Do not use oil- or grease-based lubricants on isolators as they deteriorate the rubber.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Loosen the clamp, separate the isolator from the hanger and remove:
^
An extension pipe for Expedition models.
^
A resonator for Navigator models.
^
To install, tighten to 48 Nm (35 ft. lbs.).
3. Remove the 4 nuts and 2 stabilizer bar brackets.
^
Allow the bar to hang from the links.
^
To install, tighten to 55 Nm (41 ft. lbs.).
5. Detach the isolators from the muffler.