Expedition 4WD V8-5.4L VIN 5 (2006)
4. CAUTION: Care should be taken not to damage the tire pressure sensor while separating the outside bead of tire from the wheel.
Place the wheel and tire on the turntable of the tire machine, index-mark the valve stem and wheel weight positions, lubricate the bead of the tire
and dismount the outside bead of the tire from the wheel.
5. Remove the tire pressure sensor from the tire.
6. Remove and discard the grommet from the tire pressure sensor.
Installation
NOTE: The vehicle is equipped with a light blue-colored tire pressure sensor. When installing new components, use only this tire pressure sensor.
The TPM's will not operate correctly if black-colored tire pressure sensors are installed.
1. NOTE: Install a new sensor grommet or an air leak can occur.
Install a new grommet on the tire pressure sensor.
2. NOTE: Do not allow the tire to rotate relative to the rim while mounting the tire.
Lubricate and mount the outside and inside bead of the tire to the rim.
