Expedition 4WD V8-5.4L VIN 5 (2006)
9. Remove the power steering pressure line bracket-to-engine nut.
^
To install, tighten to 40 Nm (30 ft. lbs.).
Expedition vehicles
10. If equipped disconnect the power steering pressure sensor electrical connector and detach the harness retainer.
All vehicles
CAUTION: New O-ring seals must be installed any time the lines are disconnected from the steering gear.
11. Remove the power steering line clamp plate bolt and the power steering pressure line. Discard the O-ring seal.
1
To install, tighten to 23 Nm (17 ft. lbs.).
12. To install, reverse the removal procedure.
^
Using the special tool, install a new Teflon O-ring seal on the power steering pressure line-to-pump fitting.
^
Install a new O-ring seal on the clamp plate end of the power steering pressure line.
^
Fill the power steering system.
