Expedition 4WD V8-5.4L VIN 5 (2006)
1. NOTE:
-
Position the safety belt guide to the lowest position.
-
Inspect the D-ring cover for damage. If the cover is damaged or does not remain closed install a new D-ring cover.
Open the D-ring cover.
2. Remove the nut and the D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the upper B-pillar trim panel.
-
Remove the bolt cover and the bolt.
-
To install, tighten to 8 Nm (11 lb-ft).
-
Release the clips and slide the upper B-pillar panel downward.
4. Remove the safety belt shoulder height adjuster trim cover.
5. Remove the 2 bolts and the safety belt shoulder height adjuster.
-
To install, tighten to 40 Nm (30 lb-ft).
6. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
When installing the upper B-pillar trim panel, insert the safety belt guide slide into the upper B-pillar trim panel.
To install, reverse the removal procedure.
7. Check the active restraint system for correct operation.