Expedition 4WD V8-5.4L VIN 5 (2006)
Power Steering Line/Hose: Service and Repair
Power Steering Fluid Cooler to Power Steering Fluid Reservoir Return Hose
Power Steering Fluid Cooler to Power Steering Fluid Reservoir Return Hose
Material
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power
steering components can result.
All vehicles
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located near in the LH rear quarter trim panel. Failure to do
so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Failure to follow these instructions may result in personal injury.
Turn the air suspension switch to the OFF position, if equipped.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Using a suitable suction device, remove the power steering fluid from the reservoir.
4. Remove the 3 power steering reservoir bolts.
^
To install, tighten to 11 Nm (8 ft. lbs.).
5. Release the clamp, and disconnect power steering return line from the reservoir.
