Expedition 4WD V8-5.4L VIN 5 (2006)
^
Discard the bolt.
^
To install, tighten to 30 Nm (22 ft. lbs.).
3. NOTE: A new bolt must be installed.
Remove the bolt and disconnect the upper intermediate shaft from the lower intermediate shaft.
^
Discard the bolt.
^
To install, tighten to 48 Nm (35 ft. lbs.).
4. Remove the 2 bolts, the dash seal and the upper intermediate shaft.
^
To install, tighten to 12 Nm (9 ft. lbs.).
Navigator 4x4 vehicles
5. Remove the cooling fan and shroud.
All vehicles except Navigator 4x4
6. Raise and support the vehicle.
7. If equipped, remove the skid plate.
^
To install, tighten the front 2 bolts to 40 Nm (30 ft. lbs.).
^
To install, tighten the rear 2 bolts to 55 Nm (41 ft. lbs.).
All vehicles
8. NOTE: A new bolt must be installed.
Remove the bolt and the lower intermediate shaft.
^
Discard the bolt.
^
To install, tighten to 30 Nm (22 ft. lbs.).
9. To install, reverse the removal procedure.
