Expedition 4WD V8-5.4L VIN 5 (2006)
Rear Height Sensor
Removal and Installation
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle.
This can be accomplished by turning off the air suspension switch located in the LH quarter trim panel. Failure to do so may result in
unexpected inflation or deflation of the air springs, which may result in shifting of the vehicle during these operations. Failure to follow these
instructions may result in personal injury.
All sensors
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the sensor arm from the vehicle.
Front sensor
3. Remove and discard the 2 sensor nuts.
^
To install, tighten to 30 Nm (22 ft. lbs.).
Rear sensor
4. Remove and discard the sensor nuts and bolts.
^
To install, tighten to 15 Nm (13 ft. lbs.).
All sensors
5. Disconnect the sensor electrical connector.
6. NOTE: The RH and LH height sensors cannot be used on opposite sides of the vehicle.
To install, reverse the removal procedure.
7. Calibrate the height sensor.
