Expedition 4WD V8-5.4L VIN 5 (2006)
11. Position the sway bar in place and install the 4 nuts.
^
Tighten to 55 Nm (41 ft. lbs.).
12. If removed, position the axle and install the RH bolt and nut.
^
Tighten to 102 Nm (75 ft. lbs.).
13. Connect the engine oil level sensor electrical connector.
14. With the vehicle idling (600 - 750 rpm) in PARK, and the transmission temperature at 30°C - 50°C (86°F - 122°F), check and adjust the
transmission fluid level.
15. CAUTION: The fluid fill plug located on the side of the transmission is near the exhaust system. The exhaust will be extremely hot during this
procedure. Use care when working near the exhaust and the heat shields.
Remove the fluid fill plug located on the RH rear side of the case near the transmission electrical connector.
