Expedition 4WD V8-5.4L VIN 5 (2006)
2. Using the special tool, install a new manual control lever shaft seal.
3. Install the manual lever in the case.
1
Slide the manual lever in the case.
2
Position the spacer in place while sliding the manual lever into the spacer.
3
Position the manual valve inner lever while sliding the manual lever and lining up the roll pin hole.
4
Install the roll pin.
4. Position the park rod in place. Push down on the park pawl and position the park rod in place.
5. While holding the park rod down, install the park rod actuating plate.
^
Tighten to 10 Nm (89 inch lbs.).
6. Position the mechatronic assembly in place and loosely install the 10 bolts.
