Expedition 4WD V8-5.4L VIN 5 (2006)
Install the driveshaft.
^
Align the yellow dots and position the driveshaft on the transmission.
13. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the rear driveshaft and the 4 bolts.
^
Tighten to 103 Nm (76 ft. lbs.).
All vehicles
14. Lower the vehicle.
15. Fill the transmission with clean automatic transmission fluid.
^
Verify for correct operation.
^
Check for leaks.
Extension Housing Seal
Extension Housing Seal
Special Tools
Material
