Explorer 2WD V6-245 4.0L (1994)
Front Door Base Series Two Door
1. Remove the two screws retaining the door trim panel located above the door handle. Also remove one screw in the upper front portion of door trim
panel.
2. Remove trim cup at the door handle using a screwdriver or sharp object. Retention nibs will flex for easy removal.
3. At each plastic clip location, pry the door inner panel using the door trim panel removing tool from Rotunda Moulding/Trim Kit 107-00401 or
equivalent.
4. When wiring and disengagement of trim clips is completed, it is recommended that to remove panel, lift slightly to remove flange at the top of
door trim panel from trough in the glass weatherstrip. Pay special attention to the cut-out in the door trim panel for the door handle, so that it clears
the handle during removal without breakage.
NOTE: Do not pull on the trim panel to remove clips from the inner panel holes.
Installation
1. Replace any bent, damaged, or missing plastic clips on the door trim panel to the door inner panel, firmly loading clips into slots provided on door
trim panel.
2. Hold door trim panel while installing socket and bulb to illuminated courtesy lamp.
3. Load door trim panel to door assembly by first loading flange at top of door trim panel into trough in door glass weatherstrip. Align plastic clips to
holes in door inner panel and tap panel slightly to engage clips.
NOTE: Be cautious while loading panel over door handle.
4. Connect the power window and door lock control switch to the connector on the wire harness. Reinstall two screws and snap connector on harness
to power mirror control switch.
5. Reinstall power control switch plate into the opening provided, loading control switch at front edge first. Then, feeding clip in slot at rear edge,
