Rear Door Interior Handle: Paint Wears Off On Door Panel Pull Handles
PROCEDURE FOR REAR DOORS
1.
Remove the inner door trim panel. Refer to the 1994 Explorer Service Manual, Section 01-05B, for the removal procedure.
2.
Remove the door arm rest panel (Phillip screws # 2).
3.
Remove screw to pull handle.
4.
Using a trim pad removal tool (Snap-on A16B or Matco UT3M) gently push between trim panel and end of pull handle and release lock tabs,
Figure 2.
5.
Remove pull handle.
6.
Install new pull handle.
7.
Replace screw to pull handle.
8.
Reinstall arm rest pad.
9.
Reinstall the door trim panel. Refer to the 1994 Explorer Service Manual, Section 01-05B, for the installation procedure.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 94-5-9
WARRANTY STATUS:
Eligible Under The Provisions Of The Bumper To Bumper Warranty Coverage
OPERATION DESCRIPTION
TIME
940712ABT
Replace Both Rear Door
0.6 Hr.
Pull Handles
940712AB
Replace One Rear Door
0.4 Hr.
Pull Handle
940712AFT
Replace Both Front Door
1.0 Hr.
Pull Handles
940712AF
Replace One Front Door
0.6 Hr.
Pull Handle
940712AT
Replace Front And Rear
1.5 Hrs.
Door Pull Handles
DEALER CODING
BASIC PART NO.
CONDITION CODE
7022666
D5
OASIS CODES: 107000, 112000