Explorer 2WD V6-245 4.0L (1994)
Axle Sensor: Service and Repair
Toothed Ring
Front
REMOVAL
1. Raise vehicle on hoist.
2. Remove wheel and tire assembly.
Rotor And Speed Sensor Ring
3. Remove caliper, rotor and hub assemblies.
NOTE: Discard speed sensor ring after removal. Do not reuse old ring.
Speed Sensor Ring Removal
4. Using a 3-jaw puller, remove indicator ring from hub.
INSTALLATION
1. Support center of hub so that wheel studs do not rest on work surface.
CAUTION: When performing the following step, make sure indicator ring is pressed on straight.