Explorer 2WD V6-245 4.0L (1994)
25. ROTATE the CID sensor CLOCKWISE past the CID switching point (from 12 to O volts).
26. ROTATE the CID sensor COUNTERCLOCKWISE and STOP at the exact point the voltmeter switches from 0 to 12 volts.
27. Tighten the CID sensor hold-down bolt to 17-21 N.m (13-15 lb-ft) using Sensor Adjusting Wrench T94T-12270-A.
28. Disconnect the testing wiring harness and the voltmeter.
29. Install oil pan.
30. Install engine front cover.
31. Install engine.
32. Fill the cooling system to the proper level with the specified coolant and bleed the cooling system.
33. Fill the crankcase with the specified quantity and grade of oil.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module
(PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
34. Connect the battery ground cable to the battery.
35. Run the engine at fast idle speed and check for coolant, fuel, vacuum and oil leaks.
