Explorer 2WD V6-245 4.0L (1994)
NOTE:
IF THE ENGINE RECEIVED HAS BOLTS INSTEAD OF GUIDE STUDS (AS IN ITEM 3, FIGURE 6), THEN TEMPORARILY REPLACE
BOLTS WITH GUIDE STUDS (E805676-S72). IF GUIDE STUDS ARE NOT IN STOCK, FABRICATE BY REMOVING THE HEADS FROM
TWO (2) BOLTS (W7OOl 66-S309). INSTALL THEM SNUGLY IN THE CYLINDER BLOCK HOLES THAT MATCH HOLES 3 AND 4
(FIGURE 7). IF GUIDE STUDS WERE ON THE VEHICLE RECEIVED, THEN LOOSEN THE STUDS 1/2 TURN BEFORE PROCEEDING.
NOTE:
THE CYLINDER HEAD(S) AND INTAKE MANIFOLD ARE TORQUED ALTERNATELY AND IN SEQUENCE TO ENSURE CORRECT FIT
AND GASKET CRUSH. FAILURE TO FOLLOW COMPLETE TORQUE SEQUENCE WILL CAUSE FOLLOW-UP REPAIR.
