Explorer 2WD V6-245 4.0L (1994)
Idle Speed: Adjustments
NOTE: Curb and fast idle speeds are controlled by the Powertrain Control Module (PCM) and Idle Air Control (IAC) valve assembly. The IAC valve
and idle speed is not adjustable. A large increase or decrease in closed plate airflow from the calibrated level will not allow effective idle speed control.
Throttle Body Assembly
Throttle bodies with sludge tolerant design are identified with a yellow/black decal. The throttle body must not be cleaned inside the bore, as this
cleaning will impair the sensitive coating. Sludge accumulation will not affect the idle air flow. The cleaning procedure for the IAC valve still applies.
RPM LIMIT CHECK PROCEDURE - Self-Test constant tone
STAR tester or equivalent scanner required
1. Activate engine running Self-Test.
2. After diagnostic trouble code 11 or 111 has been displayed, unlatch and within 4 seconds latch the Self-Test Input (STI) button.
3. A single pulse code indicates the entry mode, then observe the Self-Test Output (STO) of the STAR tester.
-
A constant tone, solid light or "STO LO" readout indicates base idle rpm is within range.
-
Beeping tone, flashing light, or STO LO readout at 8.0 Hz indicates Throttle Position (TP) is out of range due to over adjustment.
-
Beeping tone, flashing light, or STO LO readout at 4.0 Hz indicates base idle rpm is too fast.
-
Beeping tone, flashing light, or STO LO readout at 1.0 Hz indicates base idle is too slow.
4. To exit test, unlatch STI button, then wait 4 seconds for reinitialization (after 10 minutes it will exit by itself).
5. If the idle rpm (engine warm, in Neutral, A/C "Off") is not within limits, refer to Testing and Inspection / Procedures / Air Induction Diagnosis
for other possible causes of idle problem. See: Powertrain Management/Fuel Delivery and Air Induction/Testing and Inspection/Pinpoint
Tests/AIS - Air Induction Diagnosis
