Explorer 2WD V6-245 4.0L (1994)
Powertrain Control Module: Removal and Replacement
Powertrain Control Module
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module
(PCM) relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
REMOVAL
1. Open hood and disconnect negative battery cable.
2. Remove two screws and right cowl side panel.
3. Disconnect PCM electrical connector.
4. Remove three screws and PCM bracket.
5. Disconnect PCM from connector and remove.
INSTALLATION
To install PCM, reverse removal procedure.
