Explorer 2WD V6-245 4.0L (1994)
Throttle Position Sensor: Service and Repair
REMOVAL
1. Disconnect Throttle Position (TP) sensor from fuel charging wiring.
2. Remove two TP sensor retaining screws.
3. Remove TP sensor and discard TP sensor gasket.
INSTALLATION
1. Position TP sensor and gasket with connector facing rearward.
2. Secure TP sensor to throttle body with two retaining screws. Tighten to 1-2 Nm (9-18 in lb).
3. Connect electrical connector to TP sensor.
