Explorer 2WD V6-245 4.0L (1994)
9. Hand start the retaining bolt into the weld nut. Rotate the slide bar boot enough to allow the head of the Torx(R) retaining bolt to be seen.
10. Pull the slide bar against the head of the bolt. If the slide bar is not against the bolt head, it may be possible for the shoulder of the bolt to "bottom
out" on the slide bar, resulting in the slide bar not being in required alignment.
11. Torque the retaining Torx(R) bolt to 30-40 N.m (22-30 ft-lb).
12. Connect the electrical connector for the safety belt buckle switch (driver's seat only).
13. Check restraint system for proper operation.
