Explorer 2WD V6-245 4.0L (1994)
Headlamp Switch: Service and Repair
1. Disconnect battery ground cable, remove ash tray assembly and two finish panel retaining screws, then the finish panel (snaps off).
2. Remove rear window wash/wipe and heated rear light switch assembly (snaps out).
Fig. 11 Headlamp Switch Replacement.
3. Pull headlamp switch knob to ON position, then depress shaft release button on switch and remove knob and shaft assembly.
4. Remove bezel nut, pull switch down through opening, disconnect electrical connector, then remove switch.
5. Reverse procedure to install.
