Explorer 2WD V6-245 4.0L (1994)
Fig. 4 Installing Slipper Springs
4. With rotor extended upward approximately half out of cam, insert spring into rotor picket.
Fig. 5 Installing Slippers
5. Use a slipper to compress spring, then install slipper with groove facing cam.
6. Perform Steps 4 and 5 on slipper cavity beneath opposite inlet recess.
7. While holding cam stationary, index rotor left or right one space and install another spring and slipper until all ten rotor cavities have been filled.
Ensure rotor springs and slippers remain in position while turning.
8. Apply Loctite(R) Adhesive part No. 242 or 271, or equivalent, to outside diameter of seal and Lockquick(R) NF or T primer, or equivalent, to seal
bore in housing. Install rotor shaft seal using seal installer tool No. T78P-3733-A3, or equivalent. Using a plastic mallet, drive seal into bore until
properly seated.
9. Position pump plate on flat surface with pulley side facing downward.
10. Install two dowel pins and spring into housing. Spring must be inserted with dished surface facing upward.
