Explorer 2WD V6-245 4.0L (1994)
2. Start the lower screw on motor first, but do not tighten. Leave approximately one-quarter inch between screw head and motor.
3. Slide motor bracket onto motor and the lower screw.
4. Align holes in motor with bracket and install remaining two screws. Tighten all three screws.
5. Align bracket with inner panel and install rivets.
6. Connect motor wiring, and battery ground cable.
7. Check window operation.
8. Install watershield and trim panel.
Window Operational
NOTE:
If power window motor fails with glass in down position, refer to the next procedure, Rear Door Window Regulator Motor Replacement.
Removal
1. Disconnect battery ground cable.
2. Remove door trim panel and watershield. See: Body and Frame/Doors, Hood and Trunk/Doors
3. Disconnect power window motor wire from wire harness connector.
4. Remove three 1/4-inch rivets attaching the motor bracket to inner panel. Use drift pin to knock out the center pins from each rivet. Using a 1/4-inch
diameter drill, drill out the remainder of the rivet. Use care not to enlarge sheet metal holes in the door inner panel.
5. Working through access holes, remove motor attaching screws and separate motor from bracket and cable drum housing.
6. Remove motor from inside door.
Installation
1. Position the motor and drive to cable drum housing and motor mounting bracket and install three motor screws. Tighten to 2.82-5.65 N-m (25-50
in-lb).
2. Connect power window motor wiring and battery ground cable.
3. Check window operation, install watershield, door trim panel, and armrest. See: Body and Frame/Doors, Hood and Trunk/Doors
With Window Down and Inoperable
NOTE: If power window motor fails with glass in down position, refer to the next procedure, Rear Door Window Regulator Motor Replacement.
Removal
1. Disconnect battery ground cable.
2. Remove door trim panel and watershield. See: Body and Frame/Doors, Hood and Trunk/Doors
3. Disconnect power window motor wire from wire harness connector.
4. Remove three 1/4-inch rivets attaching the motor bracket to inner panel. Use drift pin to knock out the center pins from each rivet. Using a
1/4-inch diameter drill, drill out the remainder of the rivet. Use care not to enlarge sheet metal holes in the door inner panel.
5. Working through access holes, remove motor attaching screws and separate motor from bracket and cable drum housing.
6. Remove motor from inside door.