Explorer 2WD V6-245 4.0L (1994)
Wiper Motor: Service and Repair
Rear Wiper Motor
REMOVAL
1. Disconnect battery ground cable, then remove wiper arm and blade assembly.
2. Remove liftgate inner trim panel, then the motor bracket attaching screw.
3. Pull motor assembly out of rubber grommet, disconnect motor electrical connector and disengage wiring locator pins, then remove motor
assembly.
INSTALLATION
1. Position motor in liftgate rubber grommet and install attaching screws.
2. Connect motor electrical connector and install wiring locator pins.
3. Install wiper arm and blade assembly, then connect battery ground cable, and check for proper operation of wiper.
4. Install liftgate inner trim panel.