Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
previously set operation.
HI
This is the fastest wiper speed with no dwell. It is selected when the multi-function switch is in the HI speed position. If the wash button is
pressed for 0.3 to 10 seconds in this mode, the washer pump will energize until the wash switch is released.
LO
This is the slowest wiper speed with no dwell. It is selected when the multi-function switch is in the LO speed position. If the wash button is
pressed for 0.3 second, the washer pump will energized until the wash switch is released.
Chime Warning
Central Timer Module (CTM) Warning Condition Chart
There are four warning chimes and two warning lamps that are controlled by the CTM; Headlights ON warning (chime only), door ajar warning (chime
and lamp), key-in-ignition warning (chime only) and driver seat belt warning (chime and lamp). The CTM will not generate more than one audible
warning at any given time. When more than one condition requiring a CTM generated audible warning is present, the CTM will stack the warning
conditions and sound them in decreasing priority according to the Central Timer Module (CTM) Warning Condition Chart. However, the CTM will not
delay the illumination of any warning indicator lamp, even in cases where its associated audible warning only after all higher priority warnings have
completed sounding, if the given condition still exists, and the associated indicator lamp if any, is still illuminated.
Headlamp On Warning
A chime sounds when the exterior lamps are on (parking, license plate, and head lamp:
^
Ignition in OFF/LOCK position.
^
There is no key in the ignition switch.
The head lamps warning chime will stop sounding when:
^
Any one of the above conditions are removed.
Door Ajar Warning
When at least one door is ajar and the key is in the RUN or START position, the door ajar cluster lamp is activated and remains on until all
doors are closed or the ignition switch is turned from RUN to the OFF/LOCK or ACC position. A warning tone will sound any time a door
initially becomes ajar or open while the ignition switch is in the RUN position.
Driver Seat Belt Warning
The safety belt warning lamp warns that the safety belt is not fastened. The safety belt warning illuminates when it is grounded and turns OFF
when the circuit is open. The safety belt warning lamp will illuminate when:
^
Safety belt is not fastened and the ignition is turned from the OFF/LOCK or ACC positions.
The safety belt warning lamp will turn OFF when:
^
Safety belt is fastened.
^
Ignition switched from RUN or START to the OFF/LOCK or ACC positions.
^
After the lamp is illuminated for 60 seconds.
Driver Seat Belt Warning Chime
The safety belt warning chime warns that the safety belt is not fastened. The safety belt warning chime will sound when:
^
The driver's safety belt is not fastened when the ignition switch is turned from the OFF/LOCK or ACC to the RUN or START positions.
The safety belt chime will stop sounding when:
^
Safety belt is fastened.
^
Ignition switch is switched from the RUN or START to the OFF/LOCK or ACC positions.
^
After the chime has sounded for six seconds.
Key-In-Ignition Warning Chime
The key-in-ignition chime warns that the key is still in the ignition when the driver's door is ajar. The key-in-ignition warning chime will sound
when:
^
Driver's door is ajar, the ignition switch is in the OFF/LOCK or ACC position and the key is in the ignition.
