Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Braking Sensor/Switch: Service and Repair
REMOVAL:
Connecting Brake Pedal To Power Brake Booster Push Rod
-
Disconnect the brake pedal to power brake booster push rod.
1. Remove the self-locking pin.
2. Remove the brake on/off (BOO) switch.
-
Separate the (A) BOO switch from the (B) brake master cylinder push rod.
3. Remove the brake master cylinder push rod spacer (2B 129).
4. Remove the brake master cylinder push rod bushing (2474).
INSTALLATION:
-
To install, reverse the removal procedure.
