Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
REMOVAL:
Disconnecting Brake Fluid Level Warning Switch
-
Disconnect the brake master cylinder fluid level warning switch.
WARNING:BRAKE FLUID CONTAINS POLYGLYCOL ETHERS AND POLYGLYCOLS. AVOID CONTACT WITH EYES. WASH
HANDS THOROUGHLY AFTER HANDLING. IF BRAKE FLUID CONTACTS EYES, FLUSH EYES WITH RUNNING
WATER FOR 1S MINUTES. GET MEDICAL ATTENTION IF IRRITATION PERSISTS. IF TAKEN INTERNALLY,
DRINK WATER AND INDUCE VOMITING. GET MEDICAL ATTENTION IMMEDIATELY.
-
Use a suitable suction device to drain the brake master cylinder reservoir.
Removing Brake Master Cylinder Reservoir
-
Carefully pry up on the brake master cylinder reservoir to remove.
INSTALLATION:
-
Install the brake master cylinder reservoir.
1. Lubricate the two grommets with High Performance DOT 3 Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford specification
ESA-M6C25-A, DOT 3 and insert the grommets in the brake master cylinder.
2. Press the brake master cylinder reservoir into the grommets until it snaps.
3. Connect the brake master cylinder fluid level warning switch.
4. Fill the brake master cylinder reservoir with High Performance DOT 3 Brake Fluid C6AZ-1 9542-AB or DOT 3 equivalent meeting Ford
