Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
22.
Install the lower splash shield, wheel and tire and tighten lug nuts to 135 Nm (100 lb-ft) in a star pattern.
23.
Remove vehicle supports and lower the vehicle.
24.
Remove all special tools from the cylinder head.
NOTE:
Leave the top two clamp bolts loose on Camshaft Gear Holding Tool T97T-6256-B.
25.
Install the Camshaft Gear Holding Tool T97T-6256-B and Adapter T97T-6256-A onto the LH camshaft sprocket. See Figure 12.
CAUTION
It is important that the tool be installed correctly. The engine can run, badly, with one cam off by 180 degrees.
NOTE:
The camshaft timing slots are off center.
26.
Position the camshaft timing slots below the centerline of the camshaft to allow proper installation of Camshaft Holding Tool T97T-6256-C and
Adapter T97T-6256-D onto the rear of the LH cylinder head. Then, install both tools onto the cylinder head. See Figure 13.
