ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Engine - MIL Lamp ON/DTC's P0171/P0174/P1131/P1151|Page 3118 > < Campaign - Camshaft Chain Tensioner & Intake Gasket|Page 3113
Page 1
background image

Intake Manifold Gasket: All Technical Service Bulletins
Engine - MIL Lamp ON/DTC's P0171/P0174/P1131/P1151

Article No.
99-10-4

06/01/99

^

MALFUNCTION INDICATOR LAMP (MIL) - MIL
ILLUMINATED WITH DIAGNOSTIC TROUBLE
CODES (DTCS) P0171, P0174, P1131 AND/OR P1151
STORED IN MEMORY - 4.OL SOHC VEHICLES
BUILT THROUGH 1/1211998

^

LAMP - MALFUNCTION INDICATOR LAMP (MIL)
ILLUMINATED WITH DIAGNOSTIC TROUBLE
CODES (DTCS) P0171, P0174, P1131 AND/OR P1151
STORED IN MEMORY-4.OL SOHC VEHICLES
BUILT THROUGH 1/12/1998

LIGHT TRUCK:
1996-1998 EXPLORER 
1997-1998 MOUNTAINEER

This TSB article is being republished in its entirety to revise the Issue and Action.

ISSUE
On engines built prior to January 5,1998, the Malfunction Indicator Lamp (MIL) may illuminate and Diagnostic Trouble Codes (DTCs) P0171, P0174,
P1131, and/or P1151 may be present with or without driveability symptoms such as misfire, rolling idle, rough idle, etc. This may be caused by the lower
plenum-to-cylinder head 0-rings.

ACTION
Inspect for shrinking/collapsing 0-rings that will create a lean condition, usually when the engine is operating cold. The 0-rings may also be damaged
from a previous engine repair where they may "fold." When the 0-ring shrinks/folds, it will allow a very small amount of unmetered air to pass through.
Refer to the appropriate year Powertrain Control/Emissions Diagnosis (PC/ED) Service Manual for DTC diagnosis and the following Service Procedure
for details.

SERVICE PROCEDURE

1.

If the Heated Exhaust Gas Oxygen (HEGO) sensor is still targeted as the root cause, go to Step 2.

2.

Using the New Generation Star (NGS) Tester, monitor the long fuel vs. short fuel trim Parameter Identification Displays (PIDs) with the engine
cold.

a.

If a large increase + to - is noted, introduce propane around the lower intake manifold 0-rings.

b.

If the difference between the two PIDs then decrease, the concern may be with the Lower Intake Manifold 0-ring (F77Z-9461-BA). The
Upper Intake Manifold Gasket (F77Z-9E436-AA) must also be replaced as pant of this repair. Refer to the appropriate model year
Explorer/Mountaineer Workshop Manual for details.

PART NUMBER

PART NAME

F77Z-9461-BA

Lower Intake Manifold O-Ring

F77Z-9E436-AA

upper Intake Manifold Gasket

OTHER APPLICABLE ARTICLES: NONE

SUPERSEDES: 98-3-13

WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage And Emissions Warranty Coverage

OPERATION

DESCRIPTION

TIME

991004A

Perform Diagnostics And

1.6 Hrs.

Replace Intake Manifold
Gaskets

Engine - MIL Lamp ON/DTC's P0171/P0174/P1131/P1151|Page 3118 > < Campaign - Camshaft Chain Tensioner & Intake Gasket|Page 3113