Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Lamp Out Module: Service and Repair
REMOVAL
1. Position message center aside.
1. Grasp the front of the console and lift upward.
^
Position message center console aside.
2. Remove the rear floor console tray.
1. Grasp the console tray and lift upward.
^
Disconnect the power point electrical connector.
^
Disconnect the ash receptacle lamp electrical connector.
3. Remove the lamp out warning module.
NOTE: The lamp out warning module is located under the plastic console reinforcement.
1. Remove the screws.
^
Pull the lamp out warning module forward and out.
4. Disconnect the electrical connector.
INSTALLATION