Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Brake Light Switch: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Disconnect the brake on/off (BOO) switch electrical connector.
3. Remove the BOO switch.
1. Remove the self locking pin.
2. Remove the brake master cylinder push rod spacer.
3. Disconnect the (A) (BOO) switch from the (B) brake master cylinder push rod.
4. Remove the brake master cylinder push rod bushing.
5. Remove the brake master cylinder push rod spacer.
INSTALLATION
1. To install, reverse the removal procedure.
