Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Placing Wrench On RH Rear Disc Brake Bleeder Screw
1. Place a box end wrench on the RH rear disc brake caliper bleeder screw. Attach a rubber drain tube to the bleeder screw and submerge the free end
of the tube in a container partially filled with clean brake fluid.
Placing Wrench On Front Disc Brake Bleeder Screw
2. Place a box end wrench on the front disc brake caliper bleeder screw. Attach a rubber drain tube to the bleeder screw and submerge the free end of
the tube in a container partially filled with clean brake fluid.
3. Have an assistant pump the brake pedal 10 times and then hold firm pressure on the brake pedal.
4. Loosen the disc brake caliper bleeder screw until a stream of brake fluid comes out. Have an assistant maintain pressure on the brake pedal while
tightening the screw.
^
Repeat until clear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
Tightening Front Bleeder Screw
5. Tighten the front bleeder screw.
