Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
2. Partially drain the cooling system.
3. Remove the Engine Coolant Temperature (ECT) sensor.
1
Remove the ECT sensor electrical connector.
2
Remove the ECT sensor.
INSTALLATION
1. Install the ECT sensor.
1
Install the ECT sensor.
2
Connect the ECT electrical connector.
2. Fill the cooling system.
