Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
10.
Wipe all gasket surfaces with a lint free cloth.
11.
If equipped, install the throttle body spacer plate.
12.
Install the new throttle body. Tighten the bolts to 6-7 Nm (53-62 lb/in).
13.
Connect the throttle/speed control cables to the throttle body.
14.
Install the clean air tube. Tighten the retaining clamps to 3-3.5 Nm (27-31 lb/in).
15.
Connect the two (2) breather hoses to the clean air tube.
16.
Connect the IAT sensor electrical connector.
17.
Connect the TP sensor electrical connector.
18.
Install the throttle body splash shield.
19.
Connect the battery negative cable, then the remove memory saver.
20.
Check the operation of the throttle body.
