Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
IF THE SEAT IS AGAINST ITS FORWARD STOP, AN INCORRECT VERIFICATION OF THE SEAT FRAME GROUNDING WILL BE
MADE.
6.
Use an ohmmeter to verify that connection is made between the upper and lower seat track rails. Move the seat track to the full front travel
position, then move it back 25-76 mm (1-3"). Place one lead of the ohmmeter on the lower seat rail between the two (2) plastic slides, and the
second lead on the seat frame track (Figure 2). Any resistance measurement other than an open ensures proper connection/installation.
7.
For the passenger side seat, move the seat fully forward and set the height adjustment at its lowest point (this rotates the height adjustment linkage
away from the seat track area where the clip is to be installed). Lean the upper seat back toward the front of the vehicle.
8.
Repeat above Steps 2 through 6 for the passenger side seat. AFTER COMPLETING STEP 3, TILT THE PASSENGER SEAT FRAME
FORWARD (back part of seat in the full up position).
9.
Return both seats to their original position.
10.
Replace the RAP module, referring to the appropriate year Explorer/Mountaineer Service Manual procedure.
11.
Reprogram the Remote Keyless Entry Transmitters, referring to the appropriate year Explorer/Mountaineer Service Manual procedure.
12.
Inform the customer that the driver side door keypad entrance code has changed. The new code number is printed on the replacement RAP
module.
PART NUMBER
PART NAME
F77Z-78600B86-AA
Spring Clip (2/Pkg)
F7CZ-15604-EA
Remote Entry/Keyless Entry (RAP) Module
D7AZ-19A331-A
Silicone Brake Caliper Grease And Dielectric Compound
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverge
OPERATION
DESCRIPTION
TIME
970308A
Install Spring Clips And
0.8 Hr.
Replace Remote
Entry/Keyless Entry (RAP)
Module
DEALER CODING
CONDITION
BASIC PART NO.
CODE
15K602
93