Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
8. Install the ignition switch lock cylinder.
1. Align and install the ignition switch lock cylinder to the steering column.
2. Position the ignition switch lock cylinder to the off position.
9. If equipped, install the tilt wheel handle and shank.
10. Install the steering wheel.
11. Install the drive air bag module.
1. Connect the airbag sliding contact electrical connector.
2. Position the drive slide air bag module on the steering wheel.
3. Install the two driver side air bag module screws.
4. Install the two back cover plugs.