Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
2. Remove the direct clutch disc pack.
-
Inspect and replace the steel and friction plates if worn, damaged, or overheated.
CAUTION:
-
Clutch plates are directional. Note the direction of the grooves for installation.
-
If new clutch plates are being used, they should be soaked in clean transmission fluid for at least 30 minutes before assembly.
3. Use a Clutch Spring Compressor to remove the direct clutch piston retaining ring.
(1) Install the Clutch Spring Compressor and compress the direct clutch piston springs.
(2) Remove the direct clutch piston retaining ring.
WARNING: AFTER REMOVING THE RETAINING RING, USE CARE WHEN RELEASING THE PRESSURE ON THE SPRINGS.
CAUTION: Do not fully compress the Clutch Spring Compressor or damage to the spring retainer may occur.
4. Relieve the direct clutch spring tension and remove the Clutch Spring Compressor.
