Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
Fluid - A/T: Service and Repair
Description
Normal maintenance and lubrication does not necessitate periodic automatic transmission fluid changes. For severe duty applications, change the fluid at
80,450 km (50,000 miles).
To remove excess fluid, disconnect the cooler feed line at the cooler. Attach a rubber hose to the line and insert the other end into a drain pan. Crank the
engine for a short period of time (do not allow the engine to start) to remove a quantity of transmission fluid. Reattach the cooler line to the cooler. Start
the engine. Move the transmission range selector lever through all gear ranges. Recheck the fluid for the proper level. Continue to add or subtract fluid
until the proper level is reached. If a major service (e.g., clutch, band, bearing, etc.) is required, the unit will have to be removed. At this time, the torque
converter, transmission cooler, and cooler lines must be flushed to remove any contaminates.
When used under severe duty conditions the transmission fluid filter/screen assembly should be replaced at 80,450 km (50,000 miles). The transmission
fluid should be drained from the transmission and torque converter and refilled with MERCON V XT-5-QM or equivalent MERCON approved fluid as
specified to the proper level.
When filling a dry transmission and torque converter, refer to Specifications for capacity. Check the fluid level.
