Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
INSTALLATION
1. Align the flats of the manual valve inner lever with the flats on the manual control lever shaft. Install the manual valve inner lever and parking
lever actuating rod onto the manual control lever shaft.
CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup. Verify that the output shaft is
locked in the "PARK" position.
2. Install the manual valve inner lever nut.
CAUTION: Do not bend the manual valve inner lever pin.
3. Install new extension housing gasket and install the extension housing.
4. If equipped, install the transfer case.
5. Install the rear driveshaft bolts.
NOTE: Align the drive shaft with the marks made during removal to ensure correct balance.
