Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
NOTE: Minor burrs and scoring may be removed with crocus cloth. If damage is found, the pump must be replace as an assembly.
3. Install a new converter hub to housing seal onto the Converter Housing Seal Replacer.
NOTE: Check and make sure that the garter spring in the seal has not popped off of the converter hub-to-converter housing seal.
4. Use the Converter Housing Seal Replacer and install the new converter hub-to-converter housing seal into the converter housing, until it bottoms
in the housing.
CAUTION: Place the converter housing on a block of wood or equivalent to protect the converter hydraulic passages on the back side.
NOTE: Do not finish converter housing and fluid pump reassembly at this time. Assembly is completed during transmission assembly to correctly
set front end clearance.