Explorer 2WD V6-245 4.0L SOHC VIN E EFI (1997)
6. Use Pinion Bearing Cup Replacer along with Driver Handle to install the inner differential pinion bearing cup and ensure cup is fully seated.
7. Select the proper pinion adjustment shim, refer to the ring gear and drive pinion set up.
CAUTION: When selecting the pinion adjustment or damage may occur.
8. Use press and Pinion Bearing Cone Replacer to press the differential pinion bearing until it is firmly seated on the pinion and pinion shim.
9. Place a new collapsible spacer on the pinion shaft.
10. Lubricate the lip of the pinion seal and the splines on the pinion shaft with Motorcraft Synthetic Rear Axle Lubricant or equivalent meeting Ford
specification WSL-M2C192-A.
11. Install the pinion seal.
(1) Install the front pinion bearing cone and roller.
(2) Install the oil slinger in the axle housing.
(3) Install the (A) pinion seal on (B) Pinion Seal Replacer and install the pinion seal.
CAUTION: Installation without the proper tool may result in early seal failure. If the pinion seal becomes cocked during installation, remove it
