Explorer 2WD V6-245 4.0L VIN X SFI (1999)
5. Remove lower antenna mounting screw.
6. Remove the RH cowl side trim panel.
7. Disconnect the antenna motor electrical connector.
8. Remove the audio unit.
9. Position the antenna lead in cable into the engine compartment.
1
Open the glove compartment door.
2
Release the tabs and lower the glove compartment to the full open position.
3
Release the antenna lead in cable wire locators.
4
Push the antenna lead in cable into the engine compartment.
10. Move the electric antenna motor forward and down to remove.
11. If necessary, to remove a broken section of plastic antenna drive cable, remove the cover and drive mechanism.
12. Locate and remove the broken piece of drive cable.
INSTALLATION
NOTE: The antenna motor and antenna cable are installed as an assembly.
